Peptide solution concentration calculator
The calculator does one small sum, in whichever direction you need it. Mass divided by volume gives a concentration, mass divided by a concentration gives the volume to add, and a molar mass converts either figure into molar terms. The arithmetic is below, so the number the calculator returns is one you can check by hand.
Mass, volume, concentration
A vial holds a mass of solid. You add a volume of solvent. The concentration that results is the mass divided by the volume.
concentration = mass in the vial / volume of solvent added
Nothing in that sum cares which solvent you use. Bacteriostatic water, sterile water and an acetic acid solution all enter the calculation simply as volume.
A worked example
Take a vial with 10 mg on the label and add 2 mL of solvent. The concentration is 10 divided by 2, that is 5 mg/mL. A 0.2 mL portion of that solution therefore holds 1 mg of material.
Working backwards from a target
More often the concentration is fixed first and the volume is the unknown. Rearrange the same sum.
volume to add = mass in the vial / target concentration
The same 10 mg vial, at a target of 2 mg/mL, takes 5 mL. Choose a target that keeps pipetted volumes in a comfortable range: if a portion comes to a fraction of a microlitre, a small pipetting error becomes a large one.
Converting to a molar concentration
Where a method is written in molar terms, the bridge is the molar mass, the mass of one mole in grams. Note first that 1 mg/mL is the same as 1 g/L, then divide.
molar concentration in mol/L = concentration in g/L / molar mass in g/mol
For a peptide of molar mass 5000 g/mol, the 5 mg/mL solution above is 5 divided by 5000, that is 0.001 mol/L, which is 1 mmol/L or 1 mM. Catalogue entries state a molar mass where one is recorded.
The figure on the vial is nominal
The mass printed on a label is a nominal figure, the quantity the vial was filled to. The calculator works from it, because it is the number you have. The mass of peptide proper can sit below it, since the solid also holds the counterion and some retained water. Where a method needs that net content rather than the nominal figure, ask for the analytical documentation against the lot number. Both terms sit in the glossary.
Where it usually goes wrong
Three mistakes account for most of the bad numbers.
Mixing units. mg against g, mL against litres, or a molar mass in g/mol set against a concentration in mg/mL. Convert first, then divide.
Forgetting dead volume. Some liquid stays in the pipette tip and as a film on the glass. The concentration is still right, but the recoverable volume is a little less than the volume added, so plan the last portion accordingly.
Assuming the solid dissolves at once. A cake needs a moment and a gentle swirl. Drawing a portion before the solution is clear gives a concentration that is not the one you calculated. The knowledge base covers concentration, volume and molarity at greater length.
Read more
Protocol: reconstituting a lyophilised peptide vial
A bench method for dissolving a lyophilised peptide vial: choosing the volume, technique at the stopper, and what haze, foam or a floating cake means.
ReferenceReference: choosing a solvent for a peptide reagent
Bacteriostatic water, sterile water and dilute acetic acid compared: what each is for, what the preservative does and when an acid solvent helps.
StorageReference: storage temperatures for peptide reagents
A reference table of storage zones for peptide reagents, what each temperature suits, and why the date a vial was opened matters most.